
SAFETY INSTRUCTIONS
ELECTRICAL HAZARD
· To reduce risk of electrical shock
- Make sure all power to pool equipment area is off prior to any installation or removal of Clearwater
components.
- Replace damaged power pack cord immediately.
- Do not bury cord. Locate cord to minimize abuse from lawn mowers, hedge trimmers and other equipment.
· Install the power pack at least 3.05 metres (10 feet) from the inside walls of a pool to prevent any possibility of
the unit coming in contact with water.
· Your Clearwater chlorinator has been designed with an electronic flow switch. This device automatically
switches the chlorinator ‘OFF’ when the water through the cell stops. To prevent cell damage and personal
injury, do not in any way interfere with this system which has been designed for your protection.
· Never plug more than one pump at a time into a 3-pin socket (where fitted) in the base of the power supply.
EQUIPMENT WATER PRESSURE HAZARD
· Always turn pump off prior to installing or removing any Clearwater cell. Your pump and filter system operate
under pressure and the pressure must be released before you begin work. Please see your pump and filter
owner’s manual for further instructions.
· To avoid cell damage, water pressure in the cell must not exceed 200kPa (29psi).
PREVENT CHILD INJURY AND DROWNING
· To reduce the risk of injury, do not permit children to operate or perform maintenance on this product.
· Do not let anyone, especially small children, sit, step, lean, or climb on any equipment installed as part of your
pool’s operational system. Unless otherwise stated, ALL components of your pool’s operational system should
be located at least 1 metre (3 feet) from the pool so children cannot use the equipment to gain access and be
injured or drown.
IMPORTANT SAFETY INSTRUCTIONS. READ AND FOLLOW ALL INSTRUC-
TIONS. SAVE ALL INSTRUCTIONS.
WARNING Failure to heed the following warnings can result in permanent injury,
or drowning.
4
Comentários a estes Manuais