Cloud LM-2 Series Manual de Instalação descarregar pdf (Página 14)

CONTROLLER OPERATION

Controller Selection

Controller: # of Flashes: Off Time:

POLARIS Eos 1 Approximately 5 seconds

PENTAIR IntelliTouch 1 Approximately 5 seconds

JANDY AquaLink RS (rev K) 2 Approximately 5 seconds

JANDY AquaLink RS (rev L) 3 Approximately 5 seconds

After initialization for both the controller and the LM2, a software connection should have been

made. A valid connection can be verified by observing the menu screen of the controller being used.

If the chlorinator does not appear to have made a connection, try resetting both the LM2 and the

controller.

When connected to a suitable controller the LM2 behaves as a “drone”, responding only to the con-

troller, so NONE of the buttons on the LM2 will function.

Controller Disconnection

If the communication link between the controller and the LM2 is lost, the LM2 will continue opera-

tion as it was before the controller lost connection. The chlorinator will then behave as a “stand

alone” unit until the controller is reconnected or the user changes the settings.

Warning Messages on Controllers

“Low Salt”

Polaris Eos: Error code flashes “Check Chlorinator” on the screen, as well as displaying a salt level of

2900ppm, indicating that the salt level in the pool should be checked.

Jandy Aqualink RS (REV “K”): displays a salt level of 2900ppm, indicating that the salt level in the

pool should be checked.

Jandy Aqualink RS (REV “L”): displays a salt level of 2900ppm, as well as a “LOW SALT” warning

message, indicating that the salt level in the pool should be checked.

Pentair IntelliTouch: displays a salt level of 2900ppm, as well as a “LOW SALT” warning message,

indicating that the salt level in the pool should be checked.

NOTE: The “Add Salt” light will also be illuminated on the LM2 power pack. Always test the salt

level before adding additional salt.

“No Flow”

In a genuine ‘No Flow’ situation the LM2 red “No Flow” light will be illuminated on the LM2 power

pack in addition to the following screen displays:

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 35 36

Sem comentários

Cloud LM-2 Series Manual de Instalação Página 14