Cloud 36 Guia do Utilizador descarregar pdf (Página 21)

36-50 Installation and User Guide V1.0 21

APPENDIX

Table of internal jumpers and default settings

The 36-50 has various internal jumpers, the setting of which may require alteration during installation. All the jumpers are on

the main PCB. The table below lists each jumper and its purpose, together with the factory default setting.

JUMPER NAME EFFECT DEFAULT

J1 Mic phantom power OFF: MIC 1 phantom power OFF

ON: MIC 1 phantom power ON

OFF

J2 Bypass mic access port for Zone 1 PRESENT: Mic has permanent access to Z1

ABSENT: Use access port to enable access to Z1

PRESENT

J3 Bypass mic access port for Zone 2 PRESENT: Mic has permanent access to Z2

ABSENT: Use access port to enable access to Z2

PRESENT

J4 Bypass mic access port for Utility output PRESENT: Mic has permanent access to Utility output

ABSENT: Use access port to enable access to Utility output

PRESENT

J5 Zone 1 65 Hz high-pass lter OFF: full frequency response

ON: 65 Hz hi-pass lter enabled for Zone 1

OFF

J6 Music source selection – Zone 1 SW: Source follows rear panel MUSIC CONTROL switch

FR: Always via front panel only (Z1)

J7 Music source selection – Zone 2 SW: Source follows rear panel MUSIC CONTROL switch

FR: Always via front panel only (Z1)

J8 Zone 2 65 Hz high-pass lter OFF: full frequency response

ON: 65 Hz hi-pass lter enabled for Zone 2

OFF

J9 Utility output 65 Hz high-pass lter OFF: full frequency response

ON: 65 Hz hi-pass lter enabled for Utility output

OFF

J10* Utility output source select LINE 1: Utility output always uses Line 1 as source

ZONE 1: Utility output follows Zone 1 source selection

SLAVE: Utility output follows Zone source and level

ZONE 1

J11 Music ducking release time 3S: 3 seconds release time

6S: 6 seconds release time

ABSENT: 12 seconds release time

J12* Line 6 priority – Zone 1 OFF: No priority

ON: Line 6 has VOX-triggered priority over other sources in Zone 1

OFF

J13* Line 6 priority – Zone 2 OFF: No priority

ON: Line 6 has VOX-triggered priority over other sources in Zone 2

OFF

*NOTE: J10, J12 & J13 each consist of two sets of jumpers

1 2 ... 16 17 18 19 20 21 22 23 24

Comentários a estes Manuais

Sem comentários

Cloud 36 Guia do Utilizador Página 21

Comentários a estes Manuais

Manuais e produtos relacionados com Amplificadores áudio Cloud 36